6381 Windfern
Houston, TX 77040
Phone: 713-939-8903
Fax: 713-939-9013
Toll Free: 800-462-9353

Slotted Cable Hanger Application

 
Beam A 3/8 diameter 316 stainless steel weld stud is welded in the web and on the flange edge of the beam. SBS-002 slotted cable hangers (316 stainless steel) are threaded on to the weld studs. This hanger has one slot and can accommodate two cables, which are secured to the cable hanger using banding. This application is versatile because the weld stud can be stud welded on narrow areas and on thin base material allowing the most efficient routing of electrical cable.


 
Structure A 3/8 diameter 316 stainless steel weld stud is welded to the structure. As shown in the photo cable support systems can be easily attached to overhead or vertical surfaces. The studs were welded following procedures specified in American Welding Society’s “Recommended Practices for Stud Welding”. This results in a full penetration weld that develops the full strength of the fastener. The weld is as strong as the fastener and the parent metal. Also, you don’t reduce the strength of the parent material because there are no holes. An SBS-002 slotted cable hanger is threaded onto the stud. The electrical cable is secured to the hanger by use of a banding strap. This system allows cable to be routed in a safe, secure, and out of the way position underneath the traffic area.
 

 
Perimeter

 

Perimeter

A 3/8 diameter 316 stainless steel weld stud is welded around the perimeter of the cellar deck. SBS-004 slotted cable hangers are threaded onto the weld studs. This cable hanger has 3 slots and allows up to 4 cables of different diameters to be secured without bunching. Slotted cable hangers are available that can accommodate up to 8 cables. This method of securing electrical cable has with stood the test of time, maintaining its integrity through vibration, corrosion, and incidental impact for the life of the rig.

 

 
Inside Web A 3/8 diameter 316 stainless steel weld stud is welded inside of the web of the beam. An SBS-004 316 stainless steel cable hanger is threaded onto the stud and the electrical cable is secured using 316 stainless steel banding. The result is a neat and easily maintained system. Cable can be added or removed without disturbing existing cables. Different size diameter cables can be attached because each cable is under dually supported. Useful for securing cable in the harshest environments, platform decks, control rooms, switchgear buildings, heldecks, and generation modules.