 |
|
|
Subelt Stud Welding
Self-Locking Washers are used in conjunction with Sunbelt Stud Welding weld
pins, insul-anchors and lacing anchors to fasten insulation in place. Simply
press the self-locking washer onto the pin up against the insulation until the
desired position is reached and then clip off, or bend over, the remaining
portion of pin for a permanent attachment.
The choice between Round or
Square self-locking washers is basically a matter of aesthetics or personal
preference. The domed, multi-lanced hole design provides for ease of locating
washer on pin and positive self-locking. Some styles of washers are
manufactured with a beveled edge to prevent the washer from cutting into the
insulation facing.
Sunbelt Stud Welding Self-Locking Washers are
available according to the chart below and with standard 10 GA, 12 GA, or 14 GA
hole sizes off-the-shelf. Other material/plating combinations and hole sizes
are available by special order. |
|
|
|
